Woodfirst (Oil/Sealer – Linoleic Rich Long Oil Alkyd)

From R154.14 Exl VAT

WOOD1ST

CATEGORY

Wood treatment

DESCRIPTION

Wood1st has been developed to protect and stain (if necessary) both new and raw wood. It can be used alone, or as a deep penetrating primer under varnish. Wood1st contains deep penetrating oils, alkyds, pesticides and UV stabilizers. It feeds, nourishes and protects all wood from various weather conditions and mold.

FEATURES

  • Can be used as a deep penetrating wood dressing or as a sealer before varnish.
  • Nourishes natural wood types.
  • Protects against elements and acts as a UV stabilizer.
  • Creates a deep penetrating pre-varnish treatment (alkyds).

AREAS OF USE

  • Priming, staining (if required) and nourishing exterior wood before applying Paintcor’s WoodLuv or WoodCoat.
  • Oil and stain for any wooden surface.

SURFACE PREPARATION AND APPLICATION

Used alone as oil and stain

  1. Ensure that the wood is raw, new and/or untreated.
  2. Sand the wood down to a clean smooth finish, remove any sanding dust.
  3. Use Wood1st undiluted.
  4. Apply one or two coats of Wood1st as is, or use more to stain to your liking.
  5. Hard woods require one coat whereas soft woods require two coats.
  6. When wood starts to look dry (about 1 year after initial application), sand lightly and apply an additional coat.

Used as an undercoat prior to applying a varnish on outdoor surfaces. 

In order to achieve the best performance from an exterior varnish system it is essential to nourish, preserve and protect the wood before applying the varnish. This will significantly prolong the life span of the varnish and the natural wood. It is therefore important to apply Wood1st before varnishing exterior wood. For your convenience, Wood1st is available in various stains. Applying WoodLuv or WoodCoat clear varnish over Wood1st will result in a rich finish that will enhance the natural grain of the wood.

  1. Dilute Wood1st with 20% Turpentine (For hard wood only).
  2. Ensure that the natural wood is raw, new and untreated.
  3. Sand the wood to a clean smooth finish, remove any sanding dust.
  4. Apply a liberal coat of Paintcor’s Wood1st to all sides of the wood. (For best results apply Wood1st to all areas of the wood prior to assembly).
  5. Allow a drying time of 6 hours at 25°C in between coats and 12 hours before over coating with varnish.
  6. One coat of Wood1st is sufficient for hard woods. Softer woods require at least two coats of Wood1st.
  7. Apply two coats of Paintcor’s WoodLuv or WoodCoat varnish to areas of wood prior to installation.
  8. Allow sufficient time to dry in between coats.
  9. Once installation has taken place, apply 2 – 3 coats of Paintcor’s WoodLuv or WoodCoat to all exposed areas. This will seal all screw and/or nail fitment points.
  10. Allow up to 6 hours to dry in between coats.

NOTE: In order to prolong the life-span of outdoor installations, it is important to feed and seal all areas of the wood, including fixing points. Drying times are at 25°C. Additional drying time should be made by adding ? an hour for every degree below 25°C.

APPLICATION EQUIPMENT

Apply by Varnish Brush or Sponge Roller

CLEANING EQUIPMENT

Clean all equipment with Turpentine immediately after use.

STORAGE

Keep stored in cool, dry conditions and away from children. Flammable product, keep away from open flame.

Weight N/A
Shopping Cart
0
    0
    Your Cart
    Your cart is emptyReturn to Shop